How to Reset Setek WiFi Extender?
There may be times when you need to reset your Setek WiFi extender. The situation may arise in case you forgot the admin password or the extender is giving you real hard times. At times, you are tired of following all the troubleshooting steps and are left with no other choice than to reset it to the default settings. Resetting the device is the final resort. If you are stuck in such an instance and have a question in your mind about how to reset Setek WiFi extender, then this helpful guide will come in handy.
You will find instructions about resetting your extender and what will happen after you have reset it in the same guide. Thus, without any further delay, let’s get started!
Steps to Setek WiFi Extender Reset
Following are the step by step instructions to execute the reset process for your Setek wireless range extender:
Step 1: Disconnect the Devices
Commence the reset process of your extender by disconnecting any device that is connected to its network. Also, remove the Ethernet connection between the extender and the host router. This is an important step to avoid any trouble.
Step 2: Verify Power Supply
While you are resetting your extender, it is essential that it is turned on. Therefore, consider plugging it into a wall socket in case it is not yet powered on. You must make sure that the device is properly powered up and receives a stable power supply. Notice the LEDs on it. A stable power LED is an indication of a fully booted up extender.
Step 3: Reset Setek Extender
You are now on the final step to setek wifi extender reset. Find a button labeled Reset on it. It usually is inside a hole. It usually is inside a hole. Upon finding it, you need to press it gently using either a paper clip or an oil pin. However, bear in mind that the button needs to be pressed for a minimum of 10 seconds. The lights on the extender will blink and turn normal. Your extender is now reset.
What Happens When Extender is Reset?
You just learned the process of how to reset Setek WiFi extender. Let us now shed light on what exactly happens after this process. When the device is reset, this means the current configuration settings get erased from it. That means all the customized settings, passwords, etc get deleted. It becomes as good as a new device since the factory default settings get restored on it.
What to Do After Reset Process?
Now that your Setek wireless range extender is running on the factory settings, you must reconfigure it once again to access its WiFi. Setek WiFi extender setup can be executed either by using the WPS button or logging into its web interface using the IP address.
Both setup methods are simple and easy. You can use any of them according to your convenience. For your assistance, we have mentioned the WPS method below.
How to Setup Setek Extender Using WPS Button?
- Bring the Setek WiFi extender to the same room as that of the host router. This is necessary.
- Power off the router for some time.
- After waiting for about 5 minutes, turn on the router and then the extender. Ensure using well working electrical sockets to supply power to them.
- Once the devices are booted up properly, you can proceed to set up the extender.
- Find the WPS button on the router. Press it.
- Within two minutes, find and push the WPS button on your Setek extender.
- Wait for some time.
Your extender is now set up with the host router.
To Briefly Conclude
You have just reset your Setek extender and set it up again. You can now connect your client devices to its network once again to enjoy its WiFi. You can move the extender to a new location in your home. With the hope of helping you out and on a positive note, here we conclude our informative guide on how to reset Setek WiFi extender. Consider bookmarking this page in case you might need to refer to it again in the future.
