Troubleshooting: Setek SE-01

Are you troubled by Setek SE-01 setup issues? Is your Setek extender not connecting? Or are you getting a poor internet connection after using the wireless range extender? If any of these issues are giving you trouble, then this web page will help you. We have addressed the most common issues with Setek WiFi range extenders. Although we have taken Setek SE-01 as a reference, the troubleshooting steps remain the same for any other Setek extender model.

Unable to Complete Setek SE-01 Setup?

• Make sure that you are following the correct setup instructions. Refer to the Setek WiFi extender manual pdf to learn about the exact instructions for the Setek SE-01 setup.
• Connect to the extender’s network before setting up your extender.
• The Ethernet cable ought to be connected to the correct ports.
• The connection between the extender and router should be stable.
• Use an updated web browser to do the setup.
• Use the correct login details.
• Perform a power cycle before the setup process.
• Reset the extender once before setting it up.

Setek Extender Not Connecting?

• Check the Ethernet cable that is used to connect the extender and router.
• Make sure the Ethernet connection is not loose.
• Check the ports for any damage.
• If the devices are connected wirelessly, then bring them a little closer to each other.
• Both the router and extender should be receiving a consistent power supply.
• Update the extender’s firmware.

WiFi Extender SE-01 is Not Working?

• Ensure that the extender is properly configured.
• You can refer to the Setek SE-01 manual to know the setup instructions.
• Confirm that the connection between the extender and host router is stable.
• The power supply should be stable.
• Reboot the extender.
• Check all the cables connected to it.
• Perform setek SE-01 reset

Getting Poor Internet Signal from Extender?

• Place your extender away from devices that can interfere with its signal.
• The extender must be placed within range of the router’s network.
• Disconnect extra devices connected to the extender’s network.
• Make sure that the connected device is not out of range.
• Update the extender’s firmware to the latest version.
• Perform a power cycle.
• Restore the factory settings by performing Setek SE-01 reset.

Setek Extender WiFi is Not Stable?

• Verify the connections.
• Relocate the extender to the best possible location.
• The extender must sit within the boundary line of the router’s WiFi.

Extender Does Not connect to 5 GHz Network?

• Ensure that the 5 GHz WiFi band is enabled by going to the settings. Enable it right away if it is disabled.
• There is a possibility that your extender does not support a 5 GHz network.