Setek WiFi Extender Setup with Belkin Router

Setek WiFi Extenders plays a vital role in extending the network coverage by providing a boost in the system. Now we are going to discuss about the Setek WiFi Extender Setup with Belkin router in two variant methods.

• WiFi Protected Setup (WPS)
• Web Browser

Now we will discuss all three methods in detail:

Setek WiFi Extender Setup by WPS

• Choose an appropriate location between the place of Belkin router and area where you need the coverage. Plug in the Setek WiFi Extender into a power outlet midway.
• Push the WPS button on the Setek WiFi Extender so that it should start pairing up with the existing network.
• After a pause of at least two minutes, push the WPS button on the belkin router too. By doing this both will establish a connection. Solid blue blinking of LED indicator confirms the perfect connection.
• Once the connection is established, now you can unplug the extender and move it to the required zone.
• Setek WiFi Extender via Ethernet cable is a very easy process. You need to connect one end of the cable with the extender and another with the router. This process requires at least 10-15 minutes depending upon your familiarity with the device.

Setek WiFi Extender setup by Web Browser

• You can enter the Setek range extender’s IP Address 192.168.10.1.You can find it in the user manual of the extender.
• This will redirect you to the Login page where you can fill in the credentials.
• You will get the instruction to configure the Setek WiFi Extender with the existing network.
• You can save the settings, when done with the setup.

So, if you face any challenges with the setup, find some troubleshooting tips to fix the same.

Troubleshooting Tips:

Once you are done with the Setek WiFi Extender set up process, you can locate the extender to the desired location. But do keep following important steps in mind:

• You should always be mindful about extender’s placement; it should always be within the router’s range.
• Keep it away from electronic gadgets like microwave oven, radio, TV, large furniture and thick walls.
• If you face an issue like Setek Extender Not Connecting then try rebooting. Switch off both router and extender. Remove all the connected cables as well. After a pause of at least 5 minutes, set it up all over again. Turn on the belkin router first and then the extender.
• If everything fails, reset is the extender to the factory settings.

That’s all about the Setek WiFi Extender setup process and the possible fixes. You can follow the steps and set it up for a strong and smooth WiFi network throughout the premises. If you need further assistance connect with the support team.