How to Setup SETEK WiFi Extender via WPS?

Setek WiFi extender is one of the networking devices which is small and can extend your WiFi signals in home. With this device, you can easily use the internet anywhere in your house, even in the network dead zones. There are easy steps to set it up and configure via WPS method;

Setek Extender Setup via WPS

You have to connect the extender to the power first and also turn on your router. Then, follow these steps;

• Press the WPS button on the router first.
• Now find the extender WPS button and press it.
• The devices will connect within some seconds.

After establishing physical connection, you have to configure its settings to complete the Setek WiFi extender setup.

• Connect a computer or laptop to the Setek extender network via LAN cable or SSID name.
• Open/launch the web browser in your device and type in the IP address 192.168.10.1 in search bar.
• Press the Enter button to search, you will reach to the interface login page, where you have to enter the Admin credentials.
• To find the admin username and password, you can search the Label and user manual of the extender.
• Enter the credentials and you will get the access of the interface window.

From this interface, you can easily adjust or configure Setek extender settings and network, which completes the setup. There are other ways to setup the extender, in which you have to use the Ethernet cable.

Other Setup Method

The wired connection will make sure that extender and router are connected surly. To do that, you must use the Ethernet or LAN cable.

• Before supplying power to the extender, you have to connect the LAN cable to extender port.
• After that, connect the other end of the cable to the WiFi router LAN port.

Now, you can connect the extender and router to power socket, after that you have to configure. For that, you must read the above given section. You must also follow or apply some of the troubleshooting tips to secure the setup.

Troubleshooting Tips

• If you are using cables to connect, then make sure cables are not damaged or cut from anywhere.
• Make sure that the extender is connected near to the router but far away from the electronic devices.
• Check your electric wall socket is in good condition, if it is damaged then fix it or change the location of the extender.
• Restart and reset are the last option to troubleshoot any kind of technical issues related to the connection or setup.

The Conclusion

Here, you have seen and learned about how to connect or setup Setek WiFi extender via WPS button. We have also given steps to connect with cable in between.