Setek Extender Setup with WAVLINK WN586X3 Wireless Router

The Setek WiFi extender is the advanced WiFi device; it boosts the existing wifi signals and transmits them to every corner of your house. It works by connecting to the main router at the home. Here in this setup guide, you will learn how to setup the Setek wifi extender with Wavlink WN586X3 router. Let’s start:

Things You Need For Setup

• A Working Setek Extender.
• An Ethernet Cable ( For cable connection)
• Existing router (Any Brand)
• Device with Web Browser (For Configuration)

Hardware Setup

1. First of all, setting up all the devices physically is a must. Use the given steps and set your extender physically:
2. Position your Setek WiFi Extender along with the router temporarily. (You can move it after configuration.
3. Power the extender and ensure the router is also getting the proper power supply.
4. Take an Ethernet cable and make a connection between the router and extender, if you don’t want to use the WPS button for connection.

After connecting your both extender and router, configure the Setek WiFi extender through a web interface or WPS button.

WPS Button

WPS button stands for WiFi Protected Setup. Use this web interface to establish a connection between the devices. Steps to use this method

1. Push the WPS button present on the Setek device.
2. After a few seconds, hit the button of the main router in your home.
3. A light starts on both the device’s router and extender.
4. Wait for some time, when this light stops blinking.

In the WPS button, it is your wish to configure the extender using the web interface. Because it takes all the same settings of the router. But the settings like firmware update etc. use web interface.

Configuration 

But the WPS button is not on every router if your router does not have it. You need to configure the Setek WiFi extender login using the web interface.

1. Take an Ethernet cable and connect your device (laptop or computer) to the WiFi extender.
2. You can also use the Network name of the Setek WiFi extender. (Find this on the label of the extender.
3. Type IP address 192.168.10.1 into the address bar of the browser on your connected device.
4. Login with login credentials, for the first login you can use the default login information given on the sticker behind the extender.
5. Come to the extender’s setup interface; Select the main router’s SSID and password to connect your extender with the router.
6. Follow the instructions shown by the setup interface.

Once you complete the Setek WiFi extender setup, relocate the extender to the place between the dead network area and the main router in your home.

Conclusion

Sometimes it can be a bit challenging for new users to complete the Wi-Fi extender setup and login process. But by following our guide, you can easily set up your Setek extender. Even users without any technical knowledge can easily set up their Setek extender. They just need to follow the mentioned steps properly. If you still experience any problems, reach out to us for expert support.

FAQs