How to Connect Setek Extender to Nighthawk RAX200 Router?

The Setek WiFi extender is an advanced WiFi device that connects with every brand’s router. And provide high speed internet in dead zone areas in your home. A single router is not capable to reach signals in big house. So if are living in big house, and use only one router, then you need to use the Setek wifi extender with router. Here in this blog, we discuss about relevant methods that help you to Connect Setek Extender to Nighthawk RAX router. Let’s Begin:

Methods to Connect Setek WiFi Extender

In the further article, you will mainly explore two ways to connect Setek WiFi Extender Nighthawk RX Router.

Wireless Connection (WPS Button)

You will find the WPS button on Setek extender or every range extender. By using this button, you can complete Setek WiFi extender setup without any cable. The router should have WPS button. Further steps are:

• To begin, temporary keep the extender close to the router.
• Then give it power by plugging it to the power socket directly.
• Also turn on the router.
• And press the WPS button of the router.
• And after few seconds or within 2 minutes push the WPS button of the extender.
• After that wait till the blinking light on the extender turn to solid.

When a light turn solid, then move the extender to dead zone area. When you will use this method, then it is your choice to configure it or not

Wire Connection (By Computer)

Many times the router doesn’t have a WPS button, in his case; you need to use the Ethernet cable to connect Setek extender to Nighthawk RAX router. Use the steps given below

• When you use cable connection, and then keep the extender to dead zone area first.
• Use the Ethernet cable to connect the router and extender.

• Then power the extender and router also.
• After that configure the router and extender by using web interface on computer.

Configure

• Attach the computer device to the extender’s default network.
• Then use the web browser and access the login page of extender entering IP address 192.168.10.1 into address bar.
• When you will come to the Login page, fill the default login credential given on the label.
• Here click on the Login button, and check you will come to the dashboard of the web interface.
• Select the network name of the router and their password.

This way you can configure the web interface of extender by performing Setek WiFi extender login process.

Conclusion

In the above blog, you learned how to connect Setek extender to Nighthawk RAX200 router. if you have any issue, then speak to our customer support.