How to Setup Setek Extender with Wavlink Router

Configuring Setek extender with Wavlink WiFi range router amplifies the network range and speed. This blog will illustrate about the complete set up process for Setek WiFi Extender set up, which can be done in three variant modes.

• Access Point Mode

• Router Mode

• Repeater Mode

You can choose any as per your internet requirements. Let’s learn about the AP mode in detail.

Access Point Mode

This method is basically converting a wired signal into wireless one, so that multiple devices can be connected with the internet. You need to visit the AP setup wavlink page to connect the extender with wavlink router for the installation of WiFi extender. Follow the steps below:

• First of all plug in the extender into an electrical wall outlet.

• Push the power button, you may find power LED will turn green.

• Now you can connect wifi device with the EXT network.

• In the address bar of web browser type ap.setup

• Now you are on Wavlink router setup page, create an AP Login account and follow the prompted instructions.

You can also configure the Setek WiFi extender with the wavlink router via WPS process as well. Follow the instructions to proceed further:

• Place your extender near the WiFi router.
• Now switch the power on the Wavelink WiFi range extender.
• Power LED on the extender will turn green.
• You can now push the WPS button on the extender first.
• Pause for couple of minutes and press the WPS button on the router as well.
• Configuring extender with wavlink router process is done.
• Now you can login to ap.setup and complete the installation process.

This is all about setting up the Setek WiFi extender setup; now let’s walk through some troubleshooting tips to rectify the errors.

Troubleshooting Tips

Firmware Update

It is always advisable to download the latest firmware for your router from the wavlink website. Open up a web browser and login to 192.168.10.1. Browse and select the latest version of firmware available and download it.

Default Factory Reset

It is very much required to erase the customised setting and will provide you a window to start the installation from the beginning. You can login to the web interface ap.setup and enter IP address 192.168.10.1. Go to management section and click on the reset button.

WiFi Extender Placement

Make sure to place the extender within the WiFi router network coverage for configuring extender with wavlink router. Keep all kind of obstructions away for instance electromagnetic radiation producing gadgets like radio, microwave, TV etc. It is essential for the extender to receive enough signals so remove try to keep it in a visible location away from thick walls and big furniture.

Sum Up

So, this was a brief explanation about the Setek extender setup in easy steps. You can keep the troubleshooting tips in mind while setting up the device to avoid the obstructions. If you still feel stuck up then don’t hesitate to speak with the support team.